![]() ![]() Falls Sie nach mehr Softwares suchen, können Sie sich u.a. The missing tunnel manager, compatible with OpenSSH, automatic and intuitive. ![]() You can use Proxy SwitchOmega to do that. Van de ontwikkelaar: Tunnel management made easy. I do not need to add the IPs to the parameters because I do not set as system proxy and I put off enhanced mode and then configure your browsers to listen to Surge via your desired IN-PORT rules (my own case). Mac core tunnel software#MY OWN CASE (a 3rd party proxy rule based software which has it's own VIF using the lo0 is serving as my own enhanced mode □ ) Meanwhile, don't forget to add the IP address connected in core tunnel to "tun-excluded-routes" and "skip-proxy" parameters in surge to prevent loop/ring connections OR.So you might not need to add the bindinterface=lo0 (Core tunnel) and interface=lo0 (Surge) in your configurations. Ssh -N -4 -D 127.0.0.1:1010 -o BindInterface=lo0 -o ExitOnForwardFailure=yes -o ServerAliveCountMax=3 -o ServerAliveInterval=15 -p p0rt the secondary source of all my connections is through lo0 which is an interface by another Proxy-rule based software instead of Wi-Fi (en0) which is the primary source for lo0. By doing this, you get all the elegant SSH features in Core tunnel combined with the sophisticated features in Surge □ĬOR€TU₦₦€L$$H = socks5, 127.0.0.1, 1010, test-url=, interface=lo0, allow-other-interface=false, ip-version=v4-only, udp-relay=falseġ27.0.0.1:1010 is the dynamic Port forwarding IP and port in core tunnel as shown in the equivalent command below: And then I make core tunnel obey some filters (ads, tracking filters and more) in Surge by placing the IN-PORT rules that makes use of coretunnelssh policy below those filters in. Now, I use my CORE TUNNEL where all the features of SSH are elegant and then I add the Dynamic listening ports from CORE TUNNEL to Surge as a socks5 policy instead of an EXTERNAL policy because Surge is unable to launch ssh processes in my past experience. Proxy = ssh, 1.2.3.4, 22, username=root, password=pw, idle-timeout=180Īsh Yes, I made mention of this earlier but they said my requests don't make sense □ You may specify the idle timeout parameter now. (It should not be a problem since OpenSSH 7.3 was released on. It means that the SSH server must use OpenSSH v7.3 or above. Surge only supports curve25519-sha256 as the kex algorithm and aes128-gcm as the encryption algorithm. Please notice you must use base64 to encode the entire private key file again, even though the private key file uses the base64 encoding itself.Īll the four types of private keys, RSA/ECDSA/ED25519/DSA, are supported. Proxy = ssh, 1.2.3.4, 22, username=root, private-key=key1 Proxy = ssh, 1.2.3.4, 22, username=root, password=pw Mac core tunnel mac#UI configuration for Surge Mac is now available. You can now use SSH protocol as a proxy policy, an equivalent to ssh -D. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |